Version 184.108.40.206 of Flex out now A new protocol for Land Rover vehicles is now available on Flex: with this latest software update, you will be able to program MD1CP007 engine units in Bench mode. Connect your Flex to the ECU connector to access the whole content of Internal Flash and Internal EEPROM memories, then start
Version 1.1.0 of Dynomag Hub out now New software release out now for 4WD road driving simulation tests, allowing Dynomag Hub to simulate the force of a vehicle in motion on a smooth, level surface, free from tire rolling resistance, driveline losses and aerodynamic drag. Briefly, this kind of tests simulate the same force exerted by the road
Version 220.127.116.11 of Flex out now New protocol out now on Flex to program 2nd gen Getrag DC4 automatic transmissions.With this latest update (ver 18.104.22.168), it is now possible to connect TCUs both in Bench and Boot modes. You can now access the whole content of Internal Flash and Internal EEPROM memories and unlock the
Version 22.214.171.124 of Flex out now New protocol for Bosch MG1CP007 OBD unlock. Thanks to the direct connection to the diagnostic port, you will no longer need to bother removing the ECU from the vehicle: just connect the OBD cable of Flex and download the virtual read from our database to unlock the unit. You
Brand new entries for StageX Get ready for AI Solutions for the eagerly awaited Delphi & Denso ECUs, a substantial update to our mappack database, another DCU submodule solution free of charge, and AI Stage 1 for Alfa Romeos, Fiat, and Lancia vehicles. Let’s dive into it!
Version 126.96.36.199 of Flex out now Download the new update of Flex, version 188.8.131.52, and recalibrate in OBD the map area of VAG vehicles equipped with Simos19.3. Thanks to the fast OBD connection, you won’t need to remove and open the ECU to access data in the map area. With this new solution, you will