Version 8.25.0.0 of Flex Out Now
Flex version 8.25.0.0 expands support for Porsche Bosch MG1CP007 and MG1CS047 control units equipped with TC299 processors, introducing a new Boot Glitch procedure with Korhex.
Already supported through the VFI – Voltage Fault Injection technology, these Bosch MG1 ECUs can now be accessed using Korhex, without removing components from the control unit and simplifying connection directly to the TC299 processor.
This procedure enables technicians to perform the ECU Unlock via Boot Glitch with Flex and Korhex and, once the Unlock is completed, one can continue with programming operations directly in Bench mode with Flex.
In order to use the new protocol, an FLS0.20 Boot Glitch license or a Flex Full FLS0.5 configuration is required.
Contact the Magicmotorsport Sales Team to find the Flex configuration that best suits your needs, visit our shop, or open a ticket through Magic Center.
Key insights
Working Mode: Boot Glitch
Memories: Read/Write/Checksum Internal Flash, Read/Write Internal EEPROM, Full Backup
License: FLS0.20M/S – FLS0.5M/S
Connection: ~30 seconds
Reading Time: ~2 minutes 30 seconds
Writing Time: ~2 minutes
Some of the supported vehicles
Porsche 911 Carrera (IV) 992.1 (2021MY) 3.0L Boxer Twin-Turbo 24v 380HP
Porsche 911 Carrera S (IV) 992.1 (2021MY) 3.0L Boxer Twin-Turbo 24v 444HP
Porsche 911 GT3 (IV) 992.1 (2021MY) 4.0L Boxer 24v 503HP
Porsche 911 Turbo (IV) 992.1 (2021MY) 3.7L Boxer Twin-Turbo 24v 572HP
Changelog
FW update
Added recovery function for GPEC5
Fixed some unlock errors on ETC3
Fixed some USB error in Citroen AMI VCU3000 OBD protocol
Changed manual for MD1CS003 in Boot Glitch (Pin A1 -> Pin A4 , Pin A4 -> Pin A1)
Fixed time for VAG Bosch MG1CS011 and MG1CS111
Check the Privacy Policy below to proceed
