Flex version 8.21.0.0 is now available
The latest Flex update expands support for BMW Group vehicles with the introduction of Bench programming for the Bosch MG1CS003 ECU.
Equipped with an SPC5777M processor, the Bosch MG1CS003 control unit can now be programmed directly in Bench mode, no need to open the ECU or perform the unlock procedure via Boot Glitch.
This new Flex solution simplifies the ECU programming workflow: fewer steps, no ECU opening, and a faster, safer procedure.
Key insights
BMW Bosch MG1CS003 – SPC5777M
Working Mode: Bench
Memories: Read/Write/Checksum Internal Flash, Read/Write Internal EEPROM, Full Backup
License: FLS0.1M/S – FLS0.5M/S
Connection: ~10 seconds
Reading Time: ~2 minutes 30 seconds
Writing Time: ~2 minutes
Some of the supported vehicles
BMW X3 (III) G01 (2021MY) 2.0L 20i 16V 181HP
BMW 5-Series (VII) G30/G31 (2021MY) 2.0L 30e 16v PHEV 288HP
BMW 7-Series (VI) G11/G12 (2021MY) 4.4L V8 50i 32v 523HP
BMW 8-Series (I) G14/G15/G16 (2021MY) 3.0L 40i 24v 328HP
BMW Z4 (III) G29 (2021MY) 2.0L 30i 16v 254HP
Check the Privacy Policy below to proceed
