Flex version 8.13.0.0 is ready
Flex support for the VAG Group expands even further. With version 8.13.0.0, it is now possible to program the Bosch MG1CS111 ECU, equipped with a TriCore TC298 processor.
Thanks to Boot Glitch unlocking, it is possible to work on the ECU completely independently, including in Bench mode, without the need to ship it to our laboratories.
A solution that simplifies the workflow and ensures full control over the entire operation.
The new support is available to all customers with a Flex Full Master (FLS0.5M) or Flex Full Slave (FLS0.5S) license.
Key insights
- VAG Bosch MG1CS111 TC298
Working Mode: Boot Glitch – Bench
Memories: Read/Write/Checksum Internal Flash, Read/Write Internal EEPROM, Full Backup, Boot Unlock
Licenses: FLS0.5M/S
Connect/Glitch Time: ~ 5 minutes
Reading Time: ~ 2 minutes and 30 seconds
Writing Time: ~ 2 minutes
Some of the supported vehicles
Audi A3 (III) 8V (2012MY) 2.0L TSI [CZPB] 187HP
Cupra Formentor (I) (2020MY) 2.0L TSI [DKZA] 188HP
Skoda Octavia (IV) NX (2020MY) 2.0L TSI 16v [DRFA] 187HP
Volkswagen (VW) Arteon (I) 3H (2017MY) 2.0L TSI [CZPB] 187HP
Volkswagen (VW) T-Roc (I) A1 (2017MY) 2.0L TSI [CZPB] 187HP
Check the Privacy Policy below to proceed
