Version 8.23.0.0 of Flex Out Now
New Flex update, new possibilities. Now you can perform Boot Glitch operations on Stellantis Group Bosch MD1CS003 with Korhex by leveraging the EMFI – Electromagnetic Fault Injection technology on the TC298 processor.
Compared with the VFI procedure already available, Korhex allows technicians to operate without removing components from the unit, reducing the risks associated with working directly on the control unit. Moreover, the ECU can be unlocked and subsequently programmed in Bench mode.
Use the F mask to operate with Korhex, available on our shop. Alternatively, this software version also introduces the possibility to download the STL files for the dedicated Korhex positioning masks used during Boot Glitch procedures.
In order to use the protocol, an FLS0.20 Boot Glitch license or the Flex Full FLS0.5 configuration is required.
Contact the Sales Team to find the Flex configuration that best suits your needs, visit our shop, or open a ticket through Magic Center.
Key insights
Stellantis Bosch MD1CS003 – TC298
Working Mode: Boot Glitch
Memories: Read/Write/Checksum Internal Flash, Read/Write Internal EEPROM, Full Backup
License: FLS0.20M/S – FLS0.5M/S
Connection: ~10 seconds
Reading Time: ~2 minutes 30 seconds
Writing Time: ~2 minutes
Some of the supported vehicles
DS 7 Crossback (I) (2021MY) 1.5L BlueHDi 16v 130HP
FIAT Scudo (III) (2021MY) 1.5L MultiJet 16v 118HP
Opel Mokka (B) (2021MY) 1.5L TDCi 16v 108HP
Peugeot 5008 (II) (2021MY) 1.5L BlueHDi 16v 130HP
Toyota Proace City (I) (2021MY) 1.5L D4-D 16v 74HP
Changelog
- Solved some error in writing on Mercedes Bosch MD1CP001 and MG1CP002
Check the Privacy Policy below to proceed
