Version 8.14.0.0 of Flex Out Now
New programming opportunities for the motorcycle world: version 8.14.0.0 of Flex introduces support in Bench for Marelli MBC1 and MBC2 control units installed on BMW Motorrad and Husqvarna vehicles.
This new protocol allows you to work directly via pinout, simplifying programming operations and enabling the full read of the content of the unit.
A further expansion of two-wheel vehicles covered by Flex, providing professionals with new possibilities on motorbike ECUs.
Key insights
BMW Marelli MBC1 – MBC2 XC20xx
Working Mode: Bench
Memories: Read/Write/Checksum Internal Flash, Read/Write External EEPROM, Full Backup
Licenses: FLS0.1M/S – FLS0.13M/S – FLS0.5M/S
Reading Time: ~ 1 minute
Writing Time: ~ 3 minutes
Some of the supported vehicles
BMW Motorrad C 400 GT (0C06) K08 (2019MY) 350cc (E4) 34HP
BMW Motorrad C 650 GT (0133) K19 (2011MY) 650cc (E3) 59HP
BMW Motorrad G 310 GS (0G02) K02 (2017MY) 310cc (E4) 34HP
Husqvarna Nuda 900 R (I) (2011MY) 898cc (E3) 104HP
Husqvarna TR 650 (I) (2012MY) 648cc (E3) 57HP
Changelog
Bench MDG1 support for Ineos and Toyota with BMW engine added
Check the Privacy Policy below to proceed
