OBD Full and Bench Solutions for Continental M4D

Version 7.7.0.0 of Flex Out Now with OBD Full and Bench Solutions for Continental M4D

Upgrade your Flex software to the new version 7.7.0.0 and try right away the new OBD Full and Bench solutions for Continental M4D ECUs installed on motorcycles such as Ducati Streetfighter and Ducati Multistrada.

Now, you can program these last generation engine units both in OBD Full and Bench modes.

Thanks to this update, you can now easily customize and maximize two-wheel vehicle performances: just access the content of the unit via ECU connector or diagnostic port (please note: you need the new FLX2.68 cable).

Both protocols allow you to read and write the full content of the Flash memory, with virtualized EEPROM: you can restore damaged units, writing a backup from the original unit to a new working unit.

Some of the supported vehicles:

• Ducati Streetfighter 1.1L V4S 208PS
• Ducati Panigale 1100 V4S 215PS
• Ducati Multistrada 1.1L V4 170PS

This new protocol is available for the following software packages:

OBD/Bench/Boot

• FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
• FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
• FLS0.5M – SW Flex Full Master
• FLS0.5S – SW Flex Full Slave
• FLS0.13M – SW Flex Bikes OBD/Bench/Boot Master
• FLS0.13S – SW Flex Bikes OBD/Bench/Boot Slave

Newly added protocols:  

(OBD)

• Ducati Continental M4D SPC564A Read/Write/Checksum Calculation Internal Flash, Clone/Restore

Reading Time : ~ 1 minute  Writing Time : ~ 1 minute and 30 seconds

(Bench)

• Ducati Continental M4D SPC564A Read/Write/Checksum Calculation Internal Flash, Clone/Restore

Reading Time : ~ 1 minute  Writing Time : ~ 1 minute and 30 seconds

Bug fixes  

• Fixed connection error for some HW version of PSA Delphi DCM3.7 (OBD)
• Fixed unlock in Renault Continiental EMS3141
• Added new CRC types for Aisin 6HP (Cadillac and Saab)
• Added new CRC type for Mercedes Continental MCM2.1
• Added new CRC type for Ford Delphi MPC555
• Added new CRC type for Mazda Denso SHxx (2022/2023)

Software improvement

• Added Bench support for Aisin 6HP on Saab and Cadillac
• Added Bench support for Mazda Melco E6TA167x (SkyActive X MHEV)

Discover the new OBD Full and Bench Solutions for Continental M4D.

Click here to discover the full list of supported vehicles.