Version 8.8.0.0 of Flex Out Now
A new solution dedicated to industrial vehicles now enters the world of units supported by Flex. Version 8.8.0.0 introduces support for new generation Bosch MAN MD1CE100 ECUs.
One can operate on the unit independently via Boot Glitch mode and then unlock it to program it in Bench, thus obviating the need to use the RFT service and reducing working times.
This new support is available for all customers with a Flex Full Master (FLS0.5M) or Flex Full Slave (FLS0.5S) license.
Key insights
MAN Bosch MD1CE100 TC299
Working Mode: Boot Glitch – Bench
Memories: Read/Write/Checksum Internal Flash, Read/Write Internal EEPROM, Full Backup, Boot Unlock
Licenses: FLS0.5M/S
Connect/Glitch Time: From 10 seconds to 25 minutes (variable)
Reading Time: ~ 2 minutes and 30 seconds
Writing Time: ~ 2 minutes
Some of the supported vehicles
Man Trucks TGL (III) (2021MY) 4.6L Turbo 16v [D0834] 217HP
Man Trucks TGM (II) (2020MY) 6.9L Turbo 24v [D0836] 246HP
Man Trucks TGX (IV) (2021MY) 12.4L Turbo 24v [D2676] 424HP
Man Trucks TGX (IV) (2021MY) 15.2L Turbo 24v [D3876] 532HP
Man Trucks TGX (IV) (2021MY) 15.2L Turbo 24v [D3876 ] 632HP
Check the Privacy Policy below to proceed
