Flex for Ducati Continental M3D
OBD and Boot Modes Now Supported
New Flex release, version 7.55.0.0, dedicated to Ducati vehicles with Continental M3D ECUs. Program via OBD using the 4-pin MMS03.003 cable for Euro 4 models, or use Boot mode for full ECU access and backup.
Supported Vehicles
- Ducati Hypermotard 950 (I) 937cc (E4) 113HP (2019MY)
- Ducati SuperSport 939 (I) 937cc (E4) 111HP (2017MY)
- Ducati Monster 1200 (II) 1198cc (E4) 148HP (2017MY)
- Ducati Scrambler 1100 (I) 1079cc (E4) 85HP (2017MY)
This new protocol is available for the following software packages:
OBD / BOOT
- FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
- FLS0.13M – SW Flex Bikes OBD/Bench/Boot Master
- FLS0.13S – SW Flex Bikes OBD/Bench/Boot Slave
Newly added protocols:
OBD
- Ducati Continental M3D MPC5534 Read/Write/Checksum Calculation Maps
BOOT
- Ducati Continental M3D MPC5534 Read/Write/Checksum Calculation Internal Flash, Read/Write Internal EEPROM, Full Backup
Bug Fixes:
- Various bug fixes and improvements
Check the Privacy Policy below to proceed
