Version 7.15.0.0 of Flex Out Now with Bench Solution for ZF 9HP48
Flex now supports Bench solutions for ZF 9HP48 transmission units installed on Jaguar and Land Rover vehicles.
Thanks to the newest software update, you can read and write Internal Flash and Internal EEPROM memories directly via the TCU connector. This ensures safer and more efficient operations, without the risk to damage the unit.
Moreover, with this new Bench protocol, it is possible to easily carry out restoring and cloning operations: in case of a damaged TCU, you can read its full content and transfer it on a working unit, shortening work times and ensuring reliable results.
Some of the supported vehicles:
- Jaguar E-Pace X450 2.0L 300PS
- Land Rover Discovery Sport 2.0L 250PS
- Land Rover Range Rover Evoque 2.0L 240PS
Writing Time
~ 30 seconds
Read Time
~ 1 minute and 30 seconds
This new protocol is available for the following software packages:
BENCH
- FLS0.2M – SW Flex TCU OBD/Bench/Boot (car, bike, van) Master
- FLS0.2S – SW Flex TCU OBD/Bench/Boot (car, bike, van) Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
- FLS0.10M – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Master
- FLS0.10S – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Slave
This new protocol is available for the following software packages:
BENCH
- Jaguar/Land Rover ZF 9HP48 TC1782F Read/Write/Checksum Calculation Internal Flash, Read/Write Internal EEPROM, Full Backup
Check the Privacy Policy below to proceed
