Bench Solution for EDC17C45

Version 6.62.0.0 of Flex Out Now with EDC17C45 Bench Solution

Download the newest version of the software of our Flex programmer and get access to the new Bench solution for Bosch EDC17C45 engine control units installed on Nissan and Renault vehicles.

With this latest release, you can now read and write the content of Flash and EEPROM memories of engine control units.

Elaborate files that you read with Flex and optimize engine parameters in a few minutes. Get the full potential of your vehicle with this new release of the programmer signed Magicmotorsport.

Some of the supported vehicles:

• Nissan Atleon NT500 3.0L DCI 150PS
• Nissan NT400 3.0L DCI 130PS
• Renault Maxity 3.0L DCI 150PS

This new protocol is available for the following software packages:

Bench  

• FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
• FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
• FLS0.5M – SW Flex Full Master
• FLS0.5M – SW Flex Full Slave
• FLS0.10M – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Master
• FLS0.10S – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Slave

Newly added protocols:  

(BENCH)  

• All Bosch EDC17C45 TC1767 Read/Write/Checksum Calculation Internal Flash, Read/Write Internal EEPROM, Full Backup, Clone

 Reading Time: ~  1 minute and 30 seconds         Writing Time: ~ 30 seconds

Discover the Bench solution for EDC17C45.

Click here to discover the full list of supported vehicles.