Flex Version 7.29.0.0 Now Available
A new OBD Full protocol has been released for programming the Denso 112300-5920 engine control unit installed on the Suzuki Grand Vitara.
Thanks to this update, you can optimize the vehicle’s performance in just a few simple steps, without the need to remove or open the ECU.
The protocol allows reading and writing of both the Flash and EEPROM memory, enabling you to safely apply all necessary modifications directly through the diagnostic port.
Supported Vehicles
Suzuki Grand Vitara II 2.0L DOHC 140PS
New protocol available for the following software packages:
OBD Full
FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
FLS0.5M – SW Flex Full Master
FLS0.5S – SW Flex Full Slave
FLS0.6M – SW Flex OBD/Bench/Boot Renesas SH7xxxx Master
FLS0.6S – SW Flex OBD/Bench/Boot Renesas SH7xxxx Slave
Newly added protocols:
OBD Full
Suzuki Denso 112300-5920 SH7058 Read/Write/Checksum Calculation Internal Flash, Read/Write External EEPROM, Full Backup
Check the Privacy Policy below to proceed
