Ford and VW
Version 7.32.0.0 of Flex is now available, introducing support to Bosch MD1CS027 and MD1CP061 control units installed on Ford and Volkswagen vehicles, including those equipped with the newest tuning protection systems.
With this new protocol, you can operate via the diagnostic socket on Ford 2.0L and 3.0L EcoBlue Diesel and Volkswagen 2.0L and 3.0L TDI engines, without the need to previously carry out unlocking procedures: simply connect the OBD cable, read the file and write your modifications.
This Flex update covers even more recent models, up to 2025.
Some of the supported vehicles:
Ford Transit Custom I 2.0L EcoBlue 110PS
Ford Ranger IV 3.0L EcoBlue 240PS
Volkswagen Transporter T7 2.0L 170PS
Volkswagen Amarok II 3.0L TDI 240PS
This new protocol is available for the following software packages:
OBD
FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
FLS0.5M – SW Flex Full Master
FLS0.5S – SW Flex Full Slave
Newly added protocols:
OBD
Ford/VW Bosch MD1CS027 TC387 Read/Write/Checksum Calculation Maps
Ford/VW Bosch MD1CP061 TC298 Read/Write/Checksum Calculation Maps
Writing Time
~5 minutes
Reading Time
~8 minutes
Bug fixes:
Fixed connection error in some version of Ford Bosch MD1CS005
Check the Privacy Policy below to proceed
