New Ford Diesel Models Covered by Flex
New version of Flex, version 7.35.0.0, enabling OBD programming for Bosch MD1CS025 and MD1CP006 control units installed on Ford 1.5L EcoBlue Diesel and 6.7L Power Stroke Diesel engines.
Access the map zone of the engine control unit in a few minutes and make modifications to customize your vehicle driving style: boost performance, cut consumption, or remove trouble codes.
This update completes the release cycle dedicated to OBD programming of Ford Bosch MDG1 units.
Some of the supported vehicles:
Ford Tourneo Courier II 1.5L EcoBlue 100PS
Ford Transit Connect II 1.5L EcoBlue 100PS
Ford F-250 Super Duty IV 6.7L Powe Stroke 440PS
Ford F-550 Super Duty IV 6.7L Powe Stroke 440PS
This new protocol is available for the following software packages:
OBD
FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
FLS0.5M – SW Flex Full Master
FLS0.5S – SW Flex Full Slave
Newly added protocols:
OBD
-
Ford Bosch MD1CS025 TC387 Read/Write/Checksum Calculation Maps
-
Ford Bosch MD1CP006 TC298 Read/Write/Checksum Calculation Maps
Check the Privacy Policy below to proceed
