OBD, OBD on Bench, and Boot
Version 7.42.0.0 of Flex out now introducing full support to Magneti Marelli 8GMC control units installed on American market Fiat 500 cars.
Program via the diagnostic port: read, make your modifications (like power increase) and write your file directly on the control unit.
If the vehicle is not available, you can work in OBD on Bench and program the ECU via connector.
In order to clone or recover the unit, you can operate in Bootloader, too, by opening the unit and connecting to the PCB.
Some of the supported vehicles:
Fiat 500 (312) 1.4L MultiAir 16v 102PS
Fiar 500 (312) 1.4L Fire 16v 102PS
This new protocol is available for the following software packages:
OBD
FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
FLS0.5M – SW Flex Full Master
FLS0.5S – SW Flex Full Slave
BOOT
FLS0.4M – SW Flex Boot Nexus MPC5xxx Master
FLS0.4S – SW Flex Boot Nexus MPC5xxx Slave
FLS0.5M – SW Flex Full Master
FLS0.5S – SW Flex Full Slave
Newly added protocols:
OBD
FCA Marelli 8GMC MPC5565 Read/Write/Checksum Calculation Internal Flash
Writing Time
~2 minutes
Reading Time
~2 minutes
BOOT
FCA Marelli 8GMC MPC5565 Read/Write/Checksum Calculation Internal Flash, Read/Write External EEPROM, Full Backup, Clone
Check the Privacy Policy below to proceed
