Solution for Marelli 11GF Units
New release out now for Marelli 11GF control units.
This Flex update, version 7.48.0.0, allows you to Bench program FCA engine control units equipped on mild hybrid systems, extending intervention possibilities on a more modern range of vehicles.
With protocol for Marelli 11GF you can perform engine calibration operations in order to improve performance, as well as restore and clone ECUs without the need to open the unit.
It’s super easy: read the full backup of the damaged unit and transfer data to a working unit. No need to have both vehicles inside the workshop.
Some of the supported vehicles
Fiat 500 (332) 1.0L FireFly MHEV 68HP
Fiat Panda (312) 1.0L FireFly MHEV 68HP
Lancia Ypsilon (846) 1.0L FireFly MHEV 68HP
New protocol available for the following software packages:
BENCH
FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
FLS0.5M – SW Flex Full Master
FLS0.5S – SW Flex Full Slave
FLS0.10M – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Master
FLS0.10S – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Slave
Newly added protocols:
BENCH
FCA Marelli 11GF TC277 Read/Write/Checksum Calculation Internal Flash, Read/Write Internal EEPROM, Read/Write External EEPROM, Full Backup
Writing Time
~1 minute and 30 seconds
Reading Time
~2 minutes
Bug fixes:
Added support for some new versions of SID213 and EMS29xx
Software improvements:
Reading and Writing function in SID213 and EMS29xx have been speeded up
Check the Privacy Policy below to proceed
