OBD Connection for Ford USA
Version 7.34.0.0 of Flex out now, introducing OBD programming for a wide range of Bosch control units installed on Ford USA vehicles: MG1CS060, MG1CS055, MG1CS040, and MD1CP062.
With this new update, you can now access ECU calibration data in a few minutes, directly via the diagnostic socket of the vehicle, without the need to carry out complex procedures nor invasive interventions.
Thanks to this new support, modifying the engine map area becomes easier and more efficient: optimize performance, improve vehicle response, and reduce consumption, quickly and accurately.
Some of the supported vehicles:
Ford F-150 XIV 3.5L 450PS
Ford F-250 Super Duty V 6.8L 400PS
Ford F-650 Super Duty VIII 6.7L V8 330PS
Ford Bronco VI 2.3L EcoBoost 280PS
Volkswagen Amarok II 2.3L TSI
This new protocol is available for the following software packages:
OBD
FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
FLS0.5M – SW Flex Full Master
FLS0.5S – SW Flex Full Slave
Newly added protocols:
OBD
Ford Bosch MD1CP062 TC389 Read/Write/Checksum Calculation Maps
Ford Bosch MG1CS040 TC399 Read/Write/Checksum Calculation Maps
Ford Bosch MG1CS055 (beta) TC389 Read/Write/Checksum Calculation Maps
Ford Bosch MG1CS060 TC387 Read/Write/Checksum Calculation Maps
Check the Privacy Policy below to proceed
