The Italian Legend
New update of Flex, version 7.51.0.0, adding support for Marelli 12GF in OBD.
Exclusive solution now available to program last generation FCA vehicles like Fiat 500 and Fiat Pandina equipped with 1.0L FireFly mild-hybrid (petrol) engine (MHEV 70PS).
This protocol allows you to read and write the map area, performing specific optimization to improve throttle response and general vehicle efficiency.
Operational note: in order to correctly program in OBD, you must use the SGW Bypass (MMS03.001) cable, necessary to communicate with the control unit.
Once the ECU writing operation is done, unit alignment must be performed using a diagnostic tool or following the guided procedure available on Flex.
Some of the supported vehicles
Fiat 500 (332) 1.0L FireFly MHEV 70PS – 2024
Fiat Pandina (319) 1.0L FireFly MHEV 70PS – 2024
New protocol available for the following software packages:
OBD
FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
FLS0.5M – SW Flex Full Master
FLS0.5S – SW Flex Full Slave
Newly added protocols:
OBD
FCA Marelli 12GF TC377 Read/Write/Checksum Calculation Maps
Writing Time
~5 minutes
Reading Time
~12 minutes
Software improvements:
Added new Virtual Reads for Continental SID321, EMS314x and EMS316x
Check the Privacy Policy below to proceed
