Iveco Bosch MD1CS069 Now Ready
New Flex update, version 7.49.0.0, now available, implementing OBD programming for the most modern Iveco vehicles equipped with Bosch MD1CS069, even those produced after 2021.
Thanks to this new protocol, you can now work directly from the diagnostic port of the vehicle (bypassing the SGW module), or establishing direct connection through the connector.
As of today, working on the map area doesn’t require unlocking the control unit nor shipping it to us: remove DTCs, boost engine performance, or cut consumption, all in a few minutes.
Some of the supported vehicles
Iveco Daily (IV) 2.3L FPT 16v 134HP
Iveco Daily (IV) 3.0L FTP 16v 177HP
New protocol available for the following software packages:
OBD
FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
FLS0.5M – SW Flex Full Master
FLS0.5S – SW Flex Full Slave
Newly added protocols:
OBD
Iveco Bosch MD1CS069 TC299 Read/Write/Checksum Calculation Maps
Check the Privacy Policy below to proceed
