Fomoco UTCU3 TCUs Now Covered
New version 7.47.0.0 of Flex out now, introducing a new protocol dedicated to Fomoco UTCU3 TCUs installed on Ford vehicles with 6, 8, and 10-speed automatic transmissions.
With the new Flex release, you can perform OBD programming of a wide range of vehicles that are equipped with this control unit, by connecting directly to the diagnostic port.
Operating in OBD means getting quick access to the map area, making it possible to carry out necessary modifications to optimize transmission performance.
Some of the supported vehicles
Ford Bronco (VI) (2020MY) 2.7L Ecoboost V6 335PS
Ford Kuga (III) (2020MY) 1.5L EcoBoost 150PS
Ford Ranger T6 (2019MY) 2.3L Ecoboost 270PS
New protocol available for the following software packages:
OBD
FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
FLS0.5M – SW Flex Full Master
FLS0.5S – SW Flex Full Slave
Newly added protocols:
OBD
Ford Fomoco UTCU3 TC277 Read/Write/Checksum Calculation Maps
Check the Privacy Policy below to proceed
