Flex Update for Motorbikes
Version 7.38.0.0 of Flex introduces new protocols dedicated to Aprilia motorcycles.
Magneti Marelli 11MP – Aprilia, Moto Guzzi, and Piaggio
Flex supports OBD management of Magneti Marelli 11MP control units installed on different Aprilia, Moto Guzzi, and Piaggio models for reading and writing operations directly from the diagnostic port of the vehicle.
Moreover, this protocol allows you to read the real content of the control unit.
PLEASE NOTE: for OBD programming, use our FLX2.68 cable compatible with the latest EU5 motorbikes from Ducati, Honda, Suzuki, KTM, Harley, Aprilia, Yamaha, Kawasaki 6pin brands
Some of the supported vehicles:
Aprilia RSV4 1100cc 217PS
Aprilia Tuono 660cc 100PS
Moto Guzzi Stelvio 1050cc 115PS
Piaggio MP3 530cc 60PS
This new protocol is available for the following software packages:
OBD
FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
FLS0.5M – SW Flex Full Master
FLS0.5S – SW Flex Full Slave
FLS0.13M – SW Flex Bikes OBD/Bench/Boot Master
FLS0.13S – SW Flex Bikes OBD/Bench/Boot Slave
Newly added protocols:
OBD
All Marelli 11MP TC277 Read/Write/Checksum Calculation Maps
Check the Privacy Policy below to proceed
