Version 8.12.0.0 of Flex Out Now
The new Flex update introduces a world exclusive: a solution for last generation Bosch MDG1 control units installed on BMW & Mini vehicles.
Connect it. Then work in Bench!
This new protocol allows you to work directly via pinout, no need to operate in Boot Glitch mode, which means no need to open the unit to perform the unlock.
An exclusive solution to make the programming process easier, faster, and safer, optimizing your workflow and reducing working time.
Less steps.
Less risks.
Shorter working time.
This new protocol is available for:
BMW Bosch MD1CP032 TC299
BMW Bosch MD1CS001 TC298
BMW Bosch MG1CS024 TC299
BMW Bosch MG1CS049 TC298
BMW Bosch MG1CS201 TC298
Key insights
Working Mode: Bench
Memories: Read/Write/Checksum Internal Flash, Read/Write Internal EEPROM, Full Backup
License: FLS0.1M/S – FLS0.10M/S – FLS0.5M/S
Connection: ~10 seconds
Reading Time: ~2 minutes 30 seconds
Writing Time: ~2 minutes
Some of the supported vehicles
BMW 4-Series Gran Coupe (I) G26 (2021MY) 2.0L 420d MHEV 187HP
BMW M2-Series (II) G87 (2023MY) 3.0L Twin-Turbo 24v 453HP
BMW M4-Series (II) G82 (2021MY) 3.0L Twin-Turbo 24v 542HP
BMW X2-Series (II) U10 (2023MY) 2.0L 20d sDrive/xDrive MHEV 161HP
Mini Cooper (F57) (2020MY) 1.5L 139HP
Changelog
Fixed OBDFull connection problem on some DQ500 HWs
Implemented CRC on newer MDG1
Check the Privacy Policy below to proceed
