Flex Version 7.33.0.0 and New StageX Update Ready
With the release of Flex software version 7.33.0.0, OBD programming is now available for Bosch VD1CP110 control units, used in the management of AdBlue systems.
In just a few minutes, you can now have direct access to the ECU calibration data through the diagnostic port, or, if the vehicle is not available, you can also proceed via the ECU connector.
Thanks to this exclusive feature of Flex, also released on StageX, you can use automatic solutions such as error code removal or AdBlue system deactivation, all in total safety and in just a few minutes.
The SCR solution is free for StageX Plus and StageX Advanced subscribers.
Supported Vehicles
Ford Ranger IV 2.0L EcoBlue 170PS
Ford Tourneo Customer II 2.0L EcoBlue 140PS
New protocol available for the following software packages:
OBD
FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
FLS0.5M – SW Flex Full Master
FLS0.5S – SW Flex Full Slave
Newly added protocols:
OBD
Ford Bosch VD1CP110 TC375 Read/Write/Checksum Calculation Maps
Check the Privacy Policy below to proceed
