Flex Bench Support for VAG Bosch DQ500 Gen2, DQ38x, and ZF AL552

Bench for VAG DQ500 Gen2, DQ38x, and ZF AL552

VAG Automatic TCUs in Bench

Version 7.52.0.0 of Flex introduces Bench mode for Bosch DQ500 Gen2 automatic transmission control units, common on the latest VAG vehicles. Support is extended to Bosch DQ38x (2022+) and ZF AL552 Gen2 (2022+). ECU cloning is supported when the Bosch Part Number matches.

Supported Vehicles

Audi RS6 (C8) 4.0 V8 Twin-Turbo 600PS
Cupra Formentor (II) 2.0L TSI 250PS
Lamborghini Urus (I) 4.0L TFSI 650PS
Porsche Cayenne (III) 3.0L Turbo S 330PS
Skoda Octavia (IV) 1.5L TSI 150PS
Volkswagen Golf (VIII) 2.0L GTI Performance 250PS

This new protocol is available for the following software packages:

BENCH

FLS0.2M – SW Flex TCU OBD/Bench/Boot (car, bike, van) Master
FLS0.2S – SW Flex TCU OBD/Bench/Boot (car, bike, van) Slave
FLS0.5M – SW Flex Full Master
FLS0.5S – SW Flex Full Slave

Newly added protocols:

BENCH

VAG Bosch DQ500 Gen2 (2022+) Read/Write/Checksum Calculation Maps, Read/Write Internal EEPROM, Full Backup
VAG Bosch DQ38x Gen2 (2022+) Read/Write/Checksum Calculation Maps, Read/Write Internal EEPROM, Full Backup
VAG ZF AL552 Gen2 (2022+) Read/Write/Checksum Calculation Maps, Read/Write Internal EEPROM, Full Backup