Flex Bench and Boot Support for DAF Cummins CM1880/CM1881
Flex version 7.36.0.0 is ready
Supported Vehicles
- DongFeng Tianjin 4.7L 180PS
- DAF XF 106 (II) 10.8L 340PS
- DAF XF 105 12.9L 510PS
This new protocol is available for the following software packages:
BENCH/BOOT
Bench
- FLS0.4M – SW Flex Boot Nexus MPC5xxx Master
- FLS0.4S – SW Flex Boot Nexus MPC5xxx Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
- FLS0.15M – SW Flex Heavy Duty OBD/Bench/Boot Master
- FLS0.15S – SW Flex Heavy Duty OBD/Bench/Boot Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
- FLS0.15M – SW Flex Heavy Duty OBD/Bench/Boot Master
- FLS0.15S – SW Flex Heavy Duty OBD/Bench/Boot Slave
Newly added protocols:
BENCH
- DongFeng Cummins CM1880 SPC546A – Read/Write/Checksum Calculation Internal Flash
- DAF Cummins CM1881 SPC546A – Read/Write/Checksum Calculation Internal Flash
Reading Time: ~ 8 minutes Writing Time: ~ 5 minutes
BOOT
- DongFeng Cummins CM1880 SPC546A – Read/Write/Checksum Calculation Internal Flash
- DAF Cummins CM1881 SPC546A – Read/Write/Checksum Calculation Internal Flash
Reading Time: ~ 1 minute Writing Time: ~ 50 seconds
Bug Fixes:
- Software improvements
- Added Isuzu Transtron M5.2.1 in OBD and Bench mode
Check the Privacy Policy below to proceed
