Flex Support for Scania Bosch EGC4.0

Bench and Boot Programming for Industrial Vehicles

With the newly released 7.24.0.0 version of Flex, new supports have been added for industrial vehicles: now you can program the Bosch EGC4.0 control unit in Bench and Boot modes.

As of today, you can work on Scania and MAN vehicles running on methane gas (CNG), accessing the whole content of their ECU Flash and EEPROM memories.

Not just engine performance calibration and optimization, but also control unit restoring and cloning procedures in an easy and safe way: just read the full backup of the damaged unit and transfer it on the working ECU to complete the replacement.

Some of the supported vehicles:

Scania Trucks Series G340 12.7L 410PS
Scania Trucks Series R410 12.7L 410PS
MAN Bus Lion’s City A26 12.8L 310PS

This new protocol is available for the following software packages:

Bench

FLS0.5M – SW Flex Full Master
FLS0.5S – SW Flex Full Slave
FLS0.15M – SW Flex Heavy Duty OBD/Bench/Boot Master
FLS0.15S – SW Flex Heavy Duty OBD/Bench/Boot Slave

Boot

FLS0.5M – SW Flex Full Master
FLS0.5S – SW Flex Full Slave
FLS0.10M – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Master
FLS0.10S – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Slave
FLS0.15M – SW Flex Heavy Duty OBD/Bench/Boot Master
FLS0.15S – SW Flex Heavy Duty OBD/Bench/Boot Slave

Newly added protocols:

BENCH

Scania Trucks Bosch EGC4.0 TC1797 Read/Write/Checksum Calculation Internal Flash, Read/Write/Checksum Calculation Internal EEPROM, Read/Write External EEPROM, Full Backup

Writing Time

~1 minute

Reading Time

~1 minute

BOOT

Scania Trucks Bosch EGC4.0 TC1797 Read/Write/Checksum Calculation Internal Flash, Read/Write/Checksum Calculation Internal EEPROM, Read/Write External EEPROM, Full Backup