Flex OBD Solution for Continental GPECx

Version 7.17.0.0 of Flex Out Now with a Flex OBD Solution for Continental GPECx

New release on Flex dedicated to OBD programming: a Flex OBD solution for Continental GPECx, specifically GPEC2, GPEC2A, GPEC3, GPEC4, GPEC4LM engine units.

Just unlock the unit in Boot mode and then proceed with reading and writing the map area directly via the diagnostic port of the vehicle.

Thanks to the newest update of Flex, removing the ECU every time to modify engine parameters is no longer necessary: unlock your control unit in Boot mode and then go for OBD any other time.

Some of the supported vehicles:

Chrysler 200 2.4L 180PS
Dodge RAM Promaster City 2.4L 180PS
Fiat Tipo I 1.0L Multiair 120PS
Fiat Toro 2.4L Multiair II 185PS
Jeep Compass 2.4L 180PS
Jeep Renegade 1.3L Multijet 150PS

This new protocol is available for the following software packages:

OBD

FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
FLS0.5M – SW Flex Full Master
FLS0.5S – SW Flex Full Slave

Newly added protocols:

OBD

FCA Continental GPEC2 MPC5566 Read/Write/Checksum Calculation Maps, Read External EEPROM
Reading Time : ~ 7 minutes Writing Time : ~ 4 minutes
FCA Continental GPEC2A MPC5674F Read/Write/Checksum Calculation Maps, Read External EEPROM
Reading Time : ~ 10 minutes Writing Time : ~ 5 minutes
FCA Continental GPEC3 MPC5674F Read/Write/Checksum Calculation Maps, Read External EEPROM
Reading Time : ~ 10 minutes Writing Time : ~ 5 minutes
FCA Continental GPEC4 MPC5674F Read/Write/Checksum Calculation Maps, Read External EEPROM
Reading Time : ~ 10 minutes Writing Time : ~ 5 minutes
FCA Continental GPEC4LM MPC5674F Read/Write/Checksum Calculation Maps, Read External EEPROM
Reading Time : ~ 10 minutes Writing Time : ~ 5 minutes